>A mgetty.config покажи. --------------------------------------------------------------------
#
# mgetty configuration file
#
# this is a sample configuration file, see mgetty.info for details
#
# comment lines start with a "#", empty lines are ignored
# ----- global section -----
#
# In this section, you put the global defaults, per-port stuff is below
# set the global debug level to "4" (default from policy.h)
#debug 4
# set the local fax station id
#fax-id 49 115 xxxxxxxx
# access the modem(s) with 38400 bps
#speed 38400
# use these options to make the /dev/tty-device owned by "uucp.uucp"
# and mode "rw-rw-r--" (0664). *LEADING ZERO NEEDED!*
#port-owner uucp
#port-group uucp
#port-mode 0664
# use these options to make incoming faxes owned by "root.uucp"
# and mode "rw-r-----" (0640). *LEADING ZERO NEEDED!*
#fax-owner root
#fax-group uucp
#fax-mode 0640
# ----- port specific section -----
#
# Here you can put things that are valid only for one line, not the others
#
# Zoom V.FX 28.8, connected to ttyS0: don't do fax, less logging
#
#port ttyS0
# speed 38400
# debug 3
# data-only y
# some other Rockwell modem, needs "switchbd 19200" to receive faxes
# properly (otherwise it will fail with "timeout").
#
#port ttyS1
# speed 38400
# debug 3
# data-only y
# ZyXEL 2864, connected to ttyS2: maximum debugging, grab statistics
#
#port ttyS2
# speed 57600
# data-only y
# debug 3
# init-chat "" ATZ OK
# answer-chat "" ATA CONNECT \c \r
# direct connection of a VT100 terminal which doesn't like DTR drops
#
#port ttyS3
# direct y
# speed 19200
# toggle-dtr n
port ttyS1
# speed 57600
speed 19200
data-only y
debug 8
#init-chat "" ATZ OK
init-chat "" AT+MS=V34 OK
----------------------------------------------------------------------
