Утилита эта называется Output Interpreter. Доступна только для привелегированных пользователей - обладателей сервисного контракта.
https://www.cisco.com/pcgi-bin/Support/OutputInterpreter/hom...
ROUTER CONSOLE MESSAGE NOTIFICATIONS (if any)
ERROR: The system encounters a 'Bus Error' when the processor tries to access
a memory location that either does not exist (indicating a software issue) or does
not respond properly (indicating a hardware issue).
TRY THIS:
1. For 68000 Processor based platforms, carry out the following steps:
Consider the output:
"System restarted by bus error at PC 0x30EE546, address 0xBB4C4".
Here the system is trying to access the address "0xBB4C4"
a. Based on the address accessed by the router when the 'Bus Error' occurred,
use the "show region" command to determine the memory location to which
the address corresponds. If the address reported by the 'Bus Error' does
not fall within the ranges displayed in the show region output, it implies
that the router was trying to access an invalid address. This in turn indicates
a Cisco IOS Software problem. Use the Output Interpreter to decode the output
of the "show stacks" command to identify the software bug that is causing
the bus error.
b. If the address falls within one of the ranges in the "show region" output,
it implies that the router was accessing a valid memory location, but the
hardware corresponding to that address did not respond properly. This indicates
a hardware problem. Find the memory address that the system is trying to
access (for example in the above output, it is 0xBB4C4), and also the range
of memory addresses between which this address falls. The hardware issue
is most likely related to the corresponding component. If a new router has
been installed, or if the router has been moved from one location to another,
the memory chips may have become loose. It is recommended that you re-seat
or firmly push the memory chips into the slot.
For more information, see Troubleshooting Bus Error Crashes.
2. For the RISC Processor based platforms, use the Output Interpreter Tool to decode
the output of the "show stacks" command and identify the Cisco IOS Software
bug that is causing the bus error.
REFERENCE: For more information on 'Bus Error' crashes, see
TAC Case Collection - System is in a boot loop, a bus error exception
TAC Case Collection - Router reloads due to a bus error
Troubleshooting Bus Error Crashes
REFERENCE: For more information, see:
Troubleshooting Router Crashes
http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1...
Less Common Types of System Crashes
http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1...
Короче нужен дололнительный вывод нескольких команд.
