и еще в догонку - router-ofice10#sh int tunnel0 Tunnel0 is up, line protocol is down Hardware is Tunnel Internet address is 192.168.10.200/24 MTU 1514 bytes, BW 9 Kbit/sec, DLY 500000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation TUNNEL, loopback not set Keepalive not set Tunnel source ххх.ххх.ххх.71 (FastEthernet4), destination хх.хх.х9.227 Tunnel protocol/transport GRE/IP Key disabled, sequencing disabled Checksumming of packets disabled Tunnel TTL 255 Fast tunneling enabled Tunnel transmit bandwidth 8000 (kbps) Tunnel receive bandwidth 8000 (kbps) Last input never, output 03:55:30, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 17599 Queueing strategy: fifo Output queue: 0/0 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 115251 packets output, 19671619 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 unknown protocol drops 0 output buffer failures, 0 output buffers swapped outвот это правильно, что loopback not set??? или надо всеж назначить чегото?? и Key disabled - ?? это нормально?? по циске ответтте раз уж телесис не знаете кстати если пакеты появляются (любое обращение с той или другой стороны) - железки пытаются соединиться (отладку с небольшими вариациями приводил выше) но в логах - тока 1-я фаза и после нескольких попыток - обломс.. (собстно попытки поднять канал наблюдаются пока идет обращение с любой стороны)
|