>hi I type the modprobe drxvi314 the modem starts flashin but pc just hangs up???check your usb voltage, first. Maybe you don't have enough power? Cause i had some problems.
>and i use ubuntu 10.10.
hamid! What version of kernel is you have?
Is drxvi314 compilation goes well?
There is a patch applyes during installation. For kernels above.. i don't remember. But if you what to try without this patch you can do this
1. After extracting Sprint4GDeveloperPack-1.1.tar.gz open install.sh with editor
2. find
--------------------------------------------------
cd $SRC_DIR/$BECEEM_REV_DIR/Source/Driver/Network/OSAL/Linux/usb
pm "\nConverting any DOS linebreaks (grrrr Beceem)..."
for f in `find . | grep \\\\.h`; do tr -d '\15\32' < $f > $f.conv; mv $f.conv $f; done
for f in `find . | grep \\\\.c`; do tr -d '\15\32' < $f > $f.conv; mv $f.conv $f; done
pm "Patching Beceem kernel module..."
cd $SRC_DIR/
for pf in `ls $RUN_DIR/patches/$BECEEM_DRIVER`; do
patch -p0 < $RUN_DIR/patches/$BECEEM_DRIVER/$pf
done
cd $SRC_DIR/$BECEEM_REV_DIR/Source/Driver/Network/OSAL/Linux/usb
pm "Building Beceem kernel module and driver..."
make default
make install
depmod -a
----------------------------------------------------------------------------
and remove it, save changes
3. start installation
./install.sh
It will build and copy everything except patching, compiling and installing drxvi314.ko
4. type in terminal lines below to compilate and install drxvi314.ko
cd /usr/src/USB_350/Source/Driver/Network/OSAL/Linux/usb
sudo make install
after that you can use 'sudo modprobe drxvi314'