Ошибся появляется периодически, но вроде как все работает.

И еще вопрос делаю посылать логи на хост.
При этом не работает logging buffered.
cisco 1721
rumrt01#sho ver
Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-Y7-M), Version 12.2(8)T5,  RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Thu 20-Jun-02 23:06 by ccai
Image text-base: 0x80008108, data-base: 0x808C4008

ROM: System Bootstrap, Version 12.2(7r)XM1, RELEASE SOFTWARE (fc1)

rumrt01 uptime is 1 hour, 7 minutes
System returned to ROM by power-on
System image file is "flash:c1700-y7-mz.122-8.T5.bin"

cisco 1721 (MPC860P) processor (revision 0x100) with 24576K/8192K bytes of memor
y.
Processor board ID FOC06350THS (443876449), with hardware revision 0000
MPC860P processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
Basic Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

>Привет!
>
>>После того как все было сделано получил сообщение
>>00:20:37: %PQUICC_FE-5-LATECOLL: PQUICC/FE(0/0), Late collision
>
>Появление Late collision связано с длиной ethernet сегмента.
>А что показывает show int fa 0/0?

rumrt01#sho interfaces fastEthernet 0
FastEthernet0 is up, line protocol is up
  Hardware is PQUICC_FEC, address is 000a.8aad.2359 (bia 000a.8aad.2359)
  Internet address is 213.221.1.74/30
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, 100Mb/s, 100BaseTX/FX
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue :0/40 (size/max)
  5 minute input rate 1000 bits/sec, 3 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     11421 packets input, 2367356 bytes
     Received 5696 broadcasts, 0 runts, 0 giants, 0 throttles
     3 input errors, 3 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog
     0 input packets with dribble condition detected
     6089 packets output, 1973394 bytes, 0 underruns
     3 output errors, 2 collisions, 2 interface resets
     0 babbles, 0 late collision, 0 deferred
     1 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out
rumrt01#

!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname rumrt01
!
no logging buffered
enable secret 5 $1$h6az$si1v5RPPCHxtXRrcZWwAZ.
enable password trimble
!
memory-size iomem 25
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
ip subnet-zero
no ip domain-lookup
!
isdn switch-type basic-net3
!
!
!
interface Loopback0
ip address 10.0.0.1 255.255.255.0
ip nat inside
no ip route-cache
!
interface BRI0
no ip address
ip nat outside
encapsulation ppp
dialer rotary-group 1
dialer-group 1
isdn switch-type basic-net3
no cdp enable
!
interface FastEthernet0
ip address 192.168.9.254 255.255.255.0 secondary
ip address 3.1.1.74 255.255.255.252
ip nat outside
no ip route-cache
ip policy route-map 1
speed auto
no cdp enable
!
interface Dialer1
ip address 2.4.30.10 255.255.255.0
ip nat outside
encapsulation ppp
dialer in-band
dialer idle-timeout 60
dialer string 7925222
dialer hold-queue 10
dialer load-threshold 1 either
dialer-group 1
ppp authentication chap pap callin
ppp chap hostname strisdn1
ppp chap password 0 wKElp6NZxJqC
ppp pap sent-username strisdn1 password 0 wKElp6NZxJqC
ppp multilink
!
ip nat pool ONE 3.1.1.74 3.1.1.74 netmask 255.255.255.252
ip nat inside source list 1 pool ONE overload
ip classless
ip route 0.0.0.0 0.0.0.0 3.1.1.73
no ip http server
!
!
logging trap debugging
logging facility local1
logging 213.221.1.162
access-list 1 permit 192.168.9.0 0.0.0.255
route-map 1 permit 10
match ip address 1
set interface Loopback0
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
password trimble
login
!
no scheduler allocate
end