The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]



Индекс форумов
Составление сообщения

Исходное сообщение
"Не работают GBIC"
Отправлено Гога_Тюменский, 13-Июн-06 08:26 
>покажите настройки интерфейса GBIC

cs-c3550xl#sh run int g0/1
Building configuration...

Current configuration:
!
interface GigabitEthernet0/1
no flowcontrol   <----- изначально было flowcontrol (не так ни так не работает)
no cdp enable
end

cs-c3550xl#sh int g0/1
GigabitEthernet0/1 is down, line protocol is down  <-------  при воткнутом шнурке
  Hardware is Gigabit Ethernet, address is 0007.5046.1071 (bia 0007.5046.1071)
  MTU 1500 bytes, BW 0 Kbit, DLY 0 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive not set
  Auto-duplex , 1000Mb/s, media type is T
  output flow-control is off, input flow-control is off
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 00:14:22
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 2138 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out

GigabitEthernet0/12 is up, line protocol is up <---- это его сосед на котором физика поднимается
  Hardware is Gigabit Ethernet, address is 000d.283a.508c (bia 000d.283a.508c)
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex mode, link type is force-up, media type is T
  output flow-control is unsupported, input flow-control is unsupported, 1000Mb/
s
  input flow-control is off, output flow-control is off
  ARP type: ARPA, ARP Timeout 04:00:00
  1000BaseT module (WS-G5483) in GBIC slot.
  Last input 4d00h, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue :0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     26 packets input, 2789 bytes, 0 no buffer
     Received 24 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 24 multicast, 0 pause input

 

Ваше сообщение
Имя*:
EMail:
Для отправки новых сообщений в текущей нити на email укажите знак ! перед адресом, например, !user@host.ru (!! - не показывать email).
Более тонкая настройка отправки ответов производится в профиле зарегистрированного участника форума.
Заголовок*:
Сообщение*:
 
При общении не допускается: неуважительное отношение к собеседнику, хамство, унизительное обращение, ненормативная лексика, переход на личности, агрессивное поведение, обесценивание собеседника, провоцирование флейма голословными и заведомо ложными заявлениями. Не отвечайте на сообщения, явно нарушающие правила - удаляются не только сами нарушения, но и все ответы на них. Лог модерирования.



Партнёры:
PostgresPro
Inferno Solutions
Hosting by Hoster.ru
Хостинг:

Закладки на сайте
Проследить за страницей
Created 1996-2024 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру