Исходное сообщение
"Cisco 2960. Автоподнятие порта после broadcast storm" Отправлено Юрий, 06-Дек-07 09:12
>storm-control broadcast level 5 1 >1 число порог срабатывания >2 число порог возврата Не работает. Сделал так: Switch#conf t Enter configuration commands, one per line.  End with CNTL/Z. Switch(config)#errdisable recovery interval 30 Switch(config)#int fastEthernet 0/7 Switch(config-if)#storm-control broadcast level 5 1 Switch(config-if)#exit Switch(config)#int fastEthernet 0/10 Switch(config-if)#storm-control broadcast level 5 1 Switch(config-if)#exit Switch(config)#exit Switch#wr Building configuration... [OK] Switch# Однако, в логе вижу .Dec  5 11:03:15: %PM-4-ERR_DISABLE: storm-control error detected on Fa0/10, putting Fa0/10 in err-disable state .Dec  5 11:03:15: %STORM_CONTROL-3-SHUTDOWN: A packet storm was detected on Fa0/10. The interface has been disabled. .Dec  5 11:03:16: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to down .Dec  5 11:03:17: %LINK-3-UPDOWN: Interface FastEthernet0/10, changed state to down .Dec  5 11:14:28: %SYS-5-CONFIG_I: Configured from console by vty0 (192.168.0.132) .Dec  5 11:14:30: %LINK-3-UPDOWN: Interface FastEthernet0/10, changed state to up В 11:14:28 зашел и вручную поднял интерфейс.