Исходное сообщение
"Cisco3825 не видит напрямую подключенное устройство" Отправлено Евгений, 15-Мрт-10 12:52
>sh ip arp? наличие MAC Vigor показывает sh int? #sh int gig 0/1     GigabitEthernet0/1 is up, line protocol is up   Hardware is BCM1125 Internal MAC, address is 001e.beea.cd01 (bia 001e.beea.cd01)   Internet address is 192.168.200.2/24   MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,      reliability 255/255, txload 1/255, rxload 1/255   Encapsulation ARPA, loopback not set   Keepalive set (10 sec)   Full-duplex, 100Mb/s, media type is RJ45   output flow-control is XON, input flow-control is XON   ARP type: ARPA, ARP Timeout 04:00:00   Last input 00:00:02, output 00:00:02, output hang never   Last clearing of "show interface" counters never   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0   Queueing strategy: fifo   Output queue: 0/40 (size/max)   5 minute input rate 1000 bits/sec, 2 packets/sec   5 minute output rate 0 bits/sec, 0 packets/sec      7142 packets input, 627268 bytes, 0 no buffer      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored      0 watchdog, 12 multicast, 0 pause input      0 input packets with dribble condition detected      3648 packets output, 297339 bytes, 0 underruns      8 output errors, 0 collisions, 2 interface resets      0 babbles, 0 late collision, 0 deferred      8 lost carrier, 0 no carrier, 0 pause output      0 output buffer failures, 0 output buffers swapped out ошибки вроде связаны с перегрузками Vigor ACL? никаких на Vigor пинги открыты? без ограничений