Интерактивная система просмотра системных руководств (man-ов)
apcsmart (8)
>> apcsmart (8) ( Linux man: Команды системного администрирования )
NAME
apcsmart - Driver for American Power Conversion Smart Protocol UPS equipment
NOTE
This man page only documents the hardware-specific features of the
apcsmart driver. For information about the core driver, see
nutupsdrv(8).
SUPPORTED HARDWARE
apcsmart should recognize all APC models that use a serial protocol at
2400 bps. This is primarily the Smart-UPS and Matrix-UPS lines, but some
Back-UPS Pro models are also supported.
Some older hardware may only report a handful of variables. This is
usually not a bug - they just don't support anything else.
CABLING
This driver expects to see a 940-0024C cable or a clone by default. You
can switch to the 940-0095B dual-mode cable support with the cable=
definition described below.
If your 940-0024C cable is broken or missing, use this diagram to build
a clone:
This driver supports the following optional values for -x and in the
ups.conf(5):
cable=940-0095B
Configure the serial port for the APC 940-0095B dual-mode cable.
sdtype=num
Use shutdown type num, according to this table:
0: soft shutdown or powerdown, depending on battery status
1: soft shutdown followed by powerdown
2: instant power off
3: power off with grace period
Modes 0 and 1 will power up the load when power returns. Modes 2 and 3
will keep the load turned off when the power returns.
BUGS
Some older APC UPS models return bogus data in the status register during
a front panel test. This is usually detected and discarded, but some
other unexpected values have occasionally slipped through.
