ospfd
is a routing component that works with the
zebra
routing engine.
OPTIONS
-d, --daemon
Runs in daemon mode, forking and exiting from tty.
-f, --config-file config-file
Specifies the config file to use for startup. If not specified this
option will likely default to /usr/local/etc/ospfd.conf.
-h, --help
A brief message.
-l, --log_mode
Turn verbose logging on.
-P, --vty_port port-number
Specify the port that the ospfd VTY will listen on. This defaults to
2604, as specified in /etc/services.
-v, --version
Print the version and exit.
COMMANDS
router ospf router zebra -- (Move routes into kernel table)
network [NETWORK] area [OSPF-AREA-ID] no network [NETWORK]
show ip ospf interface show ip ospf neighbor show ip ospf database show ip ospf route
debug ospf ism debug ospf packet debug ospf nsm
FILES
/usr/local/sbin/ospfd
The default location of the
ospfd
binary.
/usr/local/etc/ospfd.conf
The default location of the
ospfd
config file.
$(PWD)/ospfd.log
If the
ospfd
process is config'd to output logs to a file, then you will find this
file in the directory where you started ospfd.
WARNING
This man page is intended as a quick reference for command line
options, and for config file commands. The definitive document is the
Info file zebra.
DIAGNOSTICS
The ospfd process may log to standard output, to a VTY, to a log
file, or through syslog to the system logs. ospfd supports many
debugging options, see the Info file, or the source for details.
