>Покажите:
>sh int gi1/0/5
>sh run int gi1/0/5
>sh cdp nei det Показываю:
#sh int gi1/0/5
GigabitEthernet1/0/5 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 000e.38a8.c605 (bia 000e.38a8.c605)
Description: Int to NIKITA
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 248/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is RJ45
output flow-control is off, input flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2000 bits/sec, 2 packets/sec
5 minute output rate 11000 bits/sec, 3 packets/sec
81153731 packets input, 569814204 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
30187274 runts, 0 giants, 0 throttles
30187274 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
174115793 packets output, 153743683 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
#sh run int gi1/0/5
Building configuration...
Current configuration : 200 bytes
!
interface GigabitEthernet1/0/5
description Int to NIKITA
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 17,18
switchport mode trunk
no cdp enable
end
#sh cdp nei det
% CDP is not enabled