2851-1-1#sh run
Building configuration...
Current configuration : 3816 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname 2851-1-1
!
boot-start-marker
boot-end-marker
!
logging message-counter syslog
logging buffered 51200 warnings
enable secret 5 $1$aOV9$YcnXaxzKYPsZB/gTD8yxE1
enable password 7 107D100A11121F585E
!
no aaa new-model
network-clock-participate wic 0
network-clock-select 1 E1 0/0/0
!
dot11 syslog
ip source-route
!
!
ip cef
!
!
ip domain name nfu.xmn
no ipv6 cef
multilink bundle-name authenticated
!
!
!
!
isdn switch-type primary-net5
!
!
!
voice service voip
fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711alaw
h323
h245 tunnel disable
h245 caps mode restricted
!
!
!
voice class codec 1
codec preference 2 g729r8
codec preference 3 g723r63
codec preference 4 g711alaw
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
voice-card 0
!
!
!
!
!
username Cisco253 privilege 15 password 7 1063080B0415075A5E
archive
log config
hidekeys
!
!
controller E1 0/0/0
framing NO-CRC4
!
controller E1 0/0/1
!
!
class-map match-any DATA
match protocol http
match protocol ftp
match protocol pop3
match protocol smtp
class-map match-any VOICE
match protocol rtp
match protocol rtcp
match protocol h323
match protocol telnet
!
!
policy-map IPTEL
class VOICE
priority percent 80
set precedence 5
class DATA
bandwidth percent 10
set precedence 1
!
!
!
!
!
interface GigabitEthernet0/0
ip address 10.206.108.253 255.255.255.0
ip access-group FW_IN in
duplex auto
speed auto
no mop enabled
h323-gateway voip interface
h323-gateway voip id ##XM ipaddr 10.10.106.4 1719
h323-gateway voip h323-id nfu
h323-gateway voip bind srcaddr 10.206.108.253
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/1/0
mtu 1450
no ip address
encapsulation frame-relay
frame-relay traffic-shaping
frame-relay ip rtp header-compression
!
interface Serial0/1/0.1 point-to-point
bandwidth 512
ip unnumbered GigabitEthernet0/0
frame-relay interface-dlci 156
class VoIP-512kbps
frame-relay ip rtp header-compression
!
interface Serial0/1/0.2 point-to-point
ip unnumbered GigabitEthernet0/0
ip access-group FW_IN in
frame-relay interface-dlci 333
frame-relay ip rtp header-compression
!
interface Serial0/1/1
no ip address
shutdown
clock rate 2000000
!
router eigrp 100
network 10.0.0.0
auto-summary
!
ip forward-protocol nd
ip route 10.0.0.0 255.0.0.0 Serial0/1/0.1
ip route 192.168.1.0 255.255.255.0 Serial0/1/0.1
ip route 192.168.4.0 255.255.255.0 Serial0/1/0.1
ip route 192.168.5.0 255.255.255.0 Serial0/1/0.1
ip http server
ip http access-class 15
ip http authentication local
no ip http secure-server
!
!
!
ip access-list extended FW_IN
deny ip host 20.29.1.73 any log
deny ip any host 20.29.1.73 log
deny ip host 20.29.1.32 any
deny tcp any any eq 445 log
permit tcp any host 192.168.1.21
permit tcp any host 192.168.1.1
permit tcp any host 10.10.106.244
permit tcp any host 10.10.106.88
permit tcp any host 10.10.206.1
permit tcp any host 192.168.1.222
permit tcp any 192.168.4.0 0.0.0.255
permit ip any host 10.10.106.188
permit ip any any
!
!
map-class frame-relay VoIP-512kbps
frame-relay cir 512000
frame-relay bc 5120
frame-relay be 0
frame-relay mincir 512000
frame-relay fragment 160
service-policy output IPTEL
!
!
!
control-plane
!
!
!
!
mgcp fax t38 ecm
!
!
!
dial-peer voice 295000 pots
description ##NEFT_1
max-conn 15
destination-pattern 6814....
direct-inward-dial
forward-digits 4
!
!
gateway
timer receive-rtp 1200
!
!
line con 0
login local
line aux 0
line vty 0 4
password 7 00071A150754
login
length 0
transport input telnet ssh
line vty 5 15
password 7 130019
login local
transport input telnet ssh
!
no scheduler allocate
end
#sh version
Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(24)T, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Wed 25-Feb-09 17:55 by prod_rel_team
ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)
2851-uvd-1-1 uptime is 40 minutes
System returned to ROM by power-on
System image file is "flash:c2800nm-spservicesk9-mz.124-24.T.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 2851 (revision 53.51) with 249856K/12288K bytes of memory.
Processor board ID FCZ094870DY
2 Gigabit Ethernet interfaces
2 Serial(sync/async) interfaces
2 Channelized/Clear E1/PRI ports
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62720K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
P.S. - меня крайне смущает вот эта строчка - PVDM Slot 0:
Failed Identification Test [ 3/0 ]
Вариант для распечатки
(ok) on 26-Ноя-10, 07:29 
