Помогите решить проблему
Есть следующая схема
CallManager------|
                              |fa0/0.1    fa0/1
                              |---Cisco2611-----ADSL-------местный оператор связи
CISCO IP Phone-|
            7905

в данной конфигурации маршрутизатор 2611 выступает как Proxy, на котором настроен NAT.

Ситуация следующая
при звонке с IP Phone на городской номер, абонент на городском телефоне слышит абонента на IP Phone
Но абонент на IP Phone ничего не слышит!!!!!
есть интересный дебаг
NAT: H225: [0] processing a Setup message (Caller:302 Callee:2644733)
NAT: H225: [0] found Setup sourceCallSignalling
NAT: H225: [0] fix TransportAddress addr=10.0.101.250 port=1720
NAT: H225: [0] TransportAddress addr changed 10.0.101.250->10.10.10.15
NAT: H225: [0] TransportAddress port changed 1720->1028
NAT: H225: [0] Setup message changed, encoding back
NAT: H225: [1] processing a CallProceeding message
NAT: H225: [1] Cannot process Non-v1/v2 H.225 CallProceed
NAT: H225: [1] processing an Alerting  message
NAT: H225: [1] Cannot process Non-v1/v2 H.225 Alerting
NAT: H225: [1] processing a Connect message
NAT: H225: [1] Cannot process Non-v1/v2 H.225 Connect
NAT: H225: [0] processing a Release message
NAT: H225: [1] processing a Release message
---------------------
вот конфиг

voice rtp send-recv
!
voice service voip
!        
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server 10.0.101.250  
ccm-manager config
!        
!        
controller E1 1/0
framing NO-CRC4
pri-group timeslots 1-12,16
!        
interface FastEthernet0/0
no ip address
ip route-cache flow
duplex auto
speed auto
!        
interface FastEthernet0/0.1
description CCM
encapsulation dot1Q 101
ip address 10.0.101.254 255.255.255.0
ip directed-broadcast
ip nat inside
!        
interface FastEthernet0/1
description VoIP
ip address 10.10.10.15 255.255.255.0
ip directed-broadcast
ip nat outside
ip route-cache flow
no ip mroute-cache
speed auto
half-duplex
ntp disable
no cdp enable
h323-gateway voip bind srcaddr 10.10.10.15
!
ip nat inside source route-map ISP-NAT interface FastEthernet0/1 overload
!
access-list 2 permit 10.0.101.0 0.0.0.255
!        
route-map ISP-NAT permit 10
match ip address 2
match interface FastEthernet0/1
!
------------------------------------------------------