Интерактивная система просмотра системных руководств (man-ов)
labelit (1)
>> labelit (1) ( Solaris man: Команды и прикладные программы пользовательского уровня )
NAME
labelit - list or provide labels for file systems
SYNOPSIS
labelit [-FFSType] [-V] [-oFSType-specific-options] special
[operands]
DESCRIPTION
The labelit utility is used to write or display labels on unmounted disk file systems.
OPTIONS
The following options are supported:
-FFSType
Specify the FSType on which to operate. The FSType should either be specified here or be determinable from /etc/vfstab by matching
the special with an entry in the table. If no matching entry is found, the default file system type specified in /etc/default/fs will be used.
-V
Echo complete command line. This option may be used to verify and validate the command line. Additional information obtained using a /etc/vfstab lookup is included in the output. The command is not executed.
-o
Specify FSType-specific options. See the manual page for the labelit module specific to the file system type.
OPERANDS
The following operands are supported. If no operands are specified, labelit will display the value of the labels.
special
The disk partition (for example, /dev/rdsk/c0t3d0s6). The device may not be on a remote machine.
operands
FSType-specific operands. Consult the manual page of the FSType-specific labelit command for detailed descriptions.
USAGE
See largefile(5) for the description of the behavior of labelit when encountering files greater than or equal to 2 Gbyte ( 2^31 bytes).
EXIT STATUS
The following exit values are returned:
0
Write or display of labels was successful.
non-zero
An error occurred.
FILES
/etc/vfstab
List of default parameters for each file system.
/etc/default/fs
Default local file system type. Default values can be set for the following flags in /etc/default/fs. For example:
LOCAL=ufs LOCAL
The default partition for a command if no FSType is specified.
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
