The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

sfe (7)
  • >> sfe (7) ( Solaris man: Макропакеты и соглашения )
  •  

    NAME

    sfe - SiS900 series Fast Ethernet device driver
     
    

    SYNOPSIS

    /dev/sfe
    

     

    DESCRIPTION

    The sfe driver is a loadable, clonable, GLD-based STREAMS driver supporting the Data Link Provider Interface dlpi(7P) on Silicon Integrated Systems 900 series Fast Ethernet controllers.  

    APPLICATION PROGRAMMING INTERFACE

    The relevant fields returned as part of a DL_INFO_ACK response are:

    o Maximum SDU is 1500.
    o Minimum SDU is 0.
    o The dlsap address length is 8.
    o MAC type is DL_ETHER.
    o SAP length is -2. The 6-byte physical address is followed immediately by a 2-byte SAP.
    o Service mode is DL_CLDLS.
    o Broadcast address is the 6-byte Ethernet broadcast address (ff:ff:ff:ff:ff:ff).

    If the SAP provided is zero, then IEEE 802.3 mode is assumed and outbound frames will have the frame payload length written into the type field. Likewise, inbound frames with a SAP between zero and 1500 are interpreted as IEEE 802.3 frames and delivered to any streams that are bound to SAP zero (the 802.3 SAP).  

    PROPERTIES

    The following properties may be configured using either ndd(1M) or the sfe.conf configuration file as described by driver.conf(4):

    adv_100fdx_cap

    Enables the 100 Base TX full-duplex link option. (This is generally the fastest mode if both link partners support it. Most modern equipment supports this mode.)

    adv_100hdx_cap

    Enables the 100 Base TX half-duplex link option. (Typically used when the link partner is a 100 Mbps hub.)

    adv_10fdx_cap

    Enables the 10 Base-T full-duplex link option. (This less-frequently used mode is typically used when the link partner is a 10 Mbps switch.)

    adv_10hdx_cap

    Enables the 10 Base-T half-duplex link option. (This is the fall-back when no other option is available. It is typically used when the link partner is a 10 Mbps hub or is an older network card.)

     

    ATTRIBUTES

    See attributes(5) for a description of the following attributes:

    ATTRIBUTE TYPEATTRIBUTE VALUE

    AvailabilitySPARC, x86

    Interface Stability

     

    FILES

    /dev/sfe

    Special character device.

    /kernel/drv/sfe

    32-bit driver binary (x86).

    /kernel/drv/amd64/sfe

    64-bit driver binary (x86).

    /kernel/drv/sparcv9/sfe

    64-bit driver binary (SPARC).

    /kernel/drv/sfe.conf

    Configuration file.

     

    SEE ALSO

    ndd(1M), driver.conf(4), attributes(5), streamio(7I), dlpi(7P)

    IEEE 802.3 --- Institute of Electrical and Electronics Engineers, 2002


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    APPLICATION PROGRAMMING INTERFACE
    PROPERTIES
    ATTRIBUTES
    FILES
    SEE ALSO


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру